Set out ready for use:
Straightener / iron
Scissors
Hairspray / plastic spray
Comb
Cotton wool pads
Tissues
Before starting, you ensure your hands and nails are well cleaned. File your nails if necessary, so that there are no snags. By doing this you prevent damages on the face and risk of infection.
Always work with clean materials.
Get the subject to put on any clothes beforehand that have to be put on over the head. Protect your models clothing with a hairdressing cape or a towel.
Pulling Wool Crepe loose
Grimas Wolcrêpe is used to create beards, moustaches and eyebrows or to camouflage the edges of a beard set. It is a series of pieces of sheep's wool (approximately 15 cm in length) braided together.
Now make the piece that you are working with longer and looser: run it through your hands and pull it gently bit by bit in the lengthwise direction, but so that the piece still remains intact.
Pull the loosened piece into two in the middle, in the lengthwise direction along with the hairs; place the two pieces on top of each other and divide them into two again. Keep repeating this action until the Wool Crepe is transparent.
Note: using hairspray or plastic spray on the Wool Crepe will make it inflammable.
Protect the eyes by closing them and covering them with a tissue. Can cause serious damage to the eyes.
Fix them on top of the natural eyebrows. Apply the adhesive over the own eyebrows. Work from the inside outwards. Press the obliquely cut surface onto the adhesive and work the Wool Crepe eyebrows outwards.
Protect the eyes by closing them and covering them with a tissue. Can cause serious damage to the eyes.
You use scissors to create the desired model for the eyebrows. If necessary, open the structure a little and model them using the end of a pin-tail comb or the back of a brush. Repeat the process of cutting and opening if necessary until the desired result has been achieved.
If you have worked with Grimas Mastix Watersoluble, you can remove the Wool Crepe with lukewarm water and a little soap if necessary. Wool Crepe that has been stuck on with Mastix Extra you remove with Mastix Remover. You can then already pull some of the hairs loose and remove them with a tissue. The remaining hairs and the adhesive you remove with a cotton wool pad and Mastix Remover. Dab it carefully onto the own eyebrows and roll the residual material off the eyebrows and the skin. You can cleanse the skin with water and soap (shampoo can also be used). Cleanse afterwards with Cleansing Lotion.
