You then make the wax easier to model by applying it to the ball of your thumb and scraping it off again with the spatula two or three times. The wax must be flexible but also firm and must definitely not be allowed to get too soft and sticky.
Roll the Derma Wax into a small string and model this as the scar is to run. Smooth the edges flat so that grease and moisture can not get underneath. Smooth the Derma Wax surface and edges off with the fingertip, using a little bit of Grimas Cleansing Cream. Dab all over with a dry, clean make-up sponge. Doing this, you remove the excess Cleansing Cream and you create a skin-texture effect.
Powder the whole with a make-up sponge with Grimas Transparent Powder to matt and fix it; then turn the sponge over and continue dabbing with the clean side until the excess powder has been removed.
REMOVING THE PRODUCTS

Detach the adhesive edge with a cotton bud soaked in Grimas Mastix Remover. Scrape the Derma Wax off the skin with the spatula. Massage Grimas Multi Remover Pure or Cleansing Cream into the skin and remove with a tissue. Cleanse the skin afterwards with Grimas Cleansing Lotion.

Remove the adhesive and make-up residues from the latex prostetic with Mastix Remover. Clean the latex prostetic afterwards using water and soap, and powder it with Grimas Transparent Powder after drying (with a dryer, if necessary). Keep in a dark place.
For the best user experience, we make use of functional cookies and cookies for the managing of web statistics, advertisements and social media.