Before starting, you ensure your hands and nails are well cleaned. File your nails if necessary, so that there are no snags. By doing this you prevent damages on the face and risk of infection.
Always work using clean materials (sponges, brushes, spatulas, water bowls) and change the water regularly.
Get the subject to put on any clothes beforehand that have to be put on over the head. Protect your models clothing with a hairdressing cape or a towel.
To create an 'open wound', the Derma Wax construction has to be 'cut open' with the sharp side of a Derma Wax spatula. Lubricate the tip of the spatula with a little bit of Cleansing Cream. This will allow the spatula to slide more easily through the Derma Wax, preventing it from sticking to the spatula.
Opening the wound edges up allows you to create a tattered effect. Raise the 'wound edges' using a Derma Wax spatula, lightly lubricated with Cleansing Cream. Do this carefully.
Colouring: To add a suggestion of depth to the 'wound', colour the bottom of the wound using black make-up.
Blood
You can apply it directly from the tube or with a brush. Use a Grimas Stoppel Sponge or a tissue to disperse the blood around the 'wound', if desired.
Leave the item of clothing to soak in water containing a pre-wash (Biotex). Then wash it by hand or put it in the washing machine.
If necessary, rinse the Water Make-up clean and wipe the surfaces of the colours dry with clean tissues. Let the make-up dry out in the air and only put the lid back on when the Water Make-up is dry. Store it in a dry and cool place until the next time you use it.
The sponges are disposable so you can throw them away after use. If you do want to reuse them, first rinse them under the tap with some soap or shampoo or wash them in the washing machine (in a net bag or pillow case), set to at least 60°C.
You can clean brushes with water and soap or shampoo. Put the moist hairs of the brushes back into shape by hand after washing. Dry the brushes lying flat on a towel and do not place them upright, since that causes the moisture to run down into the shaft.