Grimas | Sinterklaas

FINISHING

You powder the face off with Grimas Transparent Powder, Fixing Powder or Make-up Powder. Apply the powder on top of the make-up. You can do this with a Make-up Sponge or a Velour Powder Puff. Allow to settle in and then remove any excess powder with a Powder Rouge Brush.

Finally, put on the wig and the mitre. Sinterklaas does not have a fringe,so hide the hair under the mitre.

= Transparent Powder

FIXING POWDER = Fixing Powder

MAKE-UP POWDER = Make-up Powder

MAKE-UP SPONGE = Make-up Sponge

VELOUR POWDER PUFF = Velour Powder Puff

BRUSHES POWDER ROUGE = Brushes Powder/Rouge

REMOVING THE PRODUCTS

Wool Crepe that has been stuck on with Mastix Extra you remove with Mastix Remover. You can then already pull some of the hairs loose and remove them with a tissue. The remaining hairs and the adhesive you remove with a cotton wool pad and Mastix Remover.
Massage Grimas Multi Remover Pure or Cleansing Cream into the skin and remove with a tissue. Cleanse the skin afterwards with Grimas Cleansing Lotion.

CLEARING UP THE MATERIALS

The sponges are disposable so you can throw them away after use. If you do want to reuse them, first rinse them under the tap with some soap or shampoo or wash them in the washing machine (in a net bag or pillow case), set to at least 60°C. You can also wash the (Velour) Powder Puff in the washing machine.

You can clean brushes with water and soap or shampoo. The Powder and Blusher Brush is cleaned like this too. Put the moist hairs of the brushes back into shape by hand after washing. Dry the brushes lying flat on a towel and do not place them upright, since that causes the moisture to run down into the shaft.

PRODUCTS